This device is used for remotely triggering the electronic shutter release of Canon cameras with a Nikon 10 Pin Remote Terminal.
This cable contains a pre-trigger switch. When enabled, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When disabled, this cable functions identically to the N90M3
Cable length: 3' (91.5 cm)
• From Nikon 10-pin Remote Terminal
• To Pre-trigger Switch
• To 1/8" (3.5 mm) Steroe Miniphone
For MultiMAX with ACC port. This cable will NOT work with the Plus II. Works with the Nikon D700 but will not work with the D200 or D100 w/MBD100 . Use theN90M-ACC cable for those cameras.
-ACC Cables are a special kind of Pre-Trigger cable for use with the new FlexTT5 or the latest MultiMAX. Toggle Pre-Trigger on and off remotely with the MultiMAX. Required for remote camera triggering with a FlexTT5 if using E-TTL functions.
NOTE: An older mono motor drive cable and/or pre-release cable can be used instead of an -ACC cable with a FlexTT5 but you will not have E-TTL capability.
Compatible with cameras using Nikon 10-pin Remote Terminal including:
• S3 Pro
• S3 Pro UVIR
• IS Pro
• DCS Pro SLR/n
• DCS Pro 14n
• DCS 760
• DCS 720x S5 Pro
• DCS 660
• DCS 660M
• DCS 620
• DCS 620x