The NEW single 10 degree hub consists of a hard-anodized aluminum hub with a 10-degree slope, a stainless steel marine grade bolt, and a high-density rubber washer.

Important:

• We strongly recommend you use a thread locker, such as LocTiteÆ 425 ONLY, as this is a fast curing, low strength adhesive for locking metal and plastics fasteners. If you have any spillage, it is advised to use an Acetone cleaner for any excess.
• Other LocTite or similar products may not be suitable for use, and are not recommended.
• The Cotton Carrier Camera System involves moving parts that must be maintained periodically. Install and, using the included Tightening Tool, tighten the Camera Insert as TIGHTLY AS POSSIBLE, as this is what keeps your camera securely attached to your Cotton Carrier. Check it until you are satisfied it is not loosening through the turning action of the camera.
• As well as confirming the condition of both the camera insert and camera receiver for any signs of wear or damage, keep both the Lexan Camera Receptacle and Camera Hub clean and free of any grit and debris, and clean it regularly as you would with any camera component.