Features:

This device is used for remotely triggering the electronic shutter release of Canon cameras with a Nikon 10 Pin Remote Terminal.

This cable contains a pre-trigger switch. When enabled, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When disabled, this cable functions identically to the N90M3

• Cable length: 3' (91.5 cm)
• From Nikon 10-pin Remote Terminal
• To Pre-trigger Switch
• To 1/8" (3.5 mm) Steroe Miniphone

For MultiMAX with ACC port. This cable will NOT work with the Plus II. Works with the Nikon D700 but will not work with the D200 or D100 w/MBD100 . Use theN90M-ACC cable for those cameras.

-ACC Cables are a special kind of Pre-Trigger cable for use with the new FlexTT5 or the latest MultiMAX. Toggle Pre-Trigger on and off remotely with the MultiMAX. Required for remote camera triggering with a FlexTT5 if using E-TTL functions.

NOTE: An older mono motor drive cable and/or pre-release cable can be used instead of an -ACC cable with a FlexTT5 but you will not have E-TTL capability.

Compatible with cameras using Nikon 10-pin Remote Terminal including:

Nikon
• N90
• N90S
• F5
• F6
• F100
• D1
• D1X
• D1H
• D2X
Nikon
• D2Xs
• D2H
• D2Hs
• D3
• D700
• D300
• D700
Fuji
• S3 Pro
• S3 Pro UVIR
• IS Pro
Kodak
• DCS Pro SLR/n
• DCS Pro 14n
• DCS 760
• DCS 720x S5 Pro
• DCS 660
• DCS 660M
• DCS 620
• DCS 620x